In stock only 
Case Accessories (3)
1-WIRE (1)Generic
BNC Boot
An insulating boot designed for use with crimp-on BNC connectors. Helps protect the cable and connector from damage.
SKU: 227842
Product Code: CPEBOOT
Availability: In Stock 
£0.12
IC 74HC595 74595 SN74HC595N 8-Bit Shift Register DIP-16
8-BIt Serial-in, Parallel-Out Shift
Wide Operating Voltage Range of 2 V to 6 V
High-Current 3-State Outputs Can Drive Up To 15 LSTTL Loads
Low Power Consumption, 80-UA Max icc
Typical tpd =…
SKU: 241498
Product Code: 74HC595-DIP-16
Availability: In Stock
£0.60
DIY Prototype Project PCB Universal Development Board 5×7 cm
Features:
1. For point to point DIY soldering
2. Material: Single Side Copper PCB
3. Hole Diameter: about 1mm
4. Hole pitch: standard 2.54mm
5. Dimension: 5x7 cm
SKU: 242398
Product Code: DIY-PCB
Availability: In Stock
£1.19
RG58 Low Loss Cable Cable (Per Metre)
• For indoor / outdoor use
• Extension cable for antennas
• Attenuates signal 3 dB
• FME-Male / FME-Female Connectors
• Requires adapters to use with 9913-equivalent cables
SKU: 227325
Product Code: RG58/1M
Availability: In Stock
£1.19
85Mm Led Tube - Red
85mm red LED Tube light
SKU: 227073
Product Code: CT-RED
Availability: In Stock
£1.19
JoyStick Breakout Module
Description
100% brand new and high quality.
PS2 joystick standard interface module electronic building blocks and 2.54mm pin interface leads.
Has a two-way rocker 10K Variable resistor.
Spring …
SKU: 242374
Product Code: PS2-JOYSTICK
Availability: In Stock
£2.39
BMP085 Barometric Pressure and Temperature Sensor - 3.3V and 5V
The BMP085 low-power, high-precision barometric pressure sensors can measure between 300 to 1100hPa with an accuracy of approximately 0.03hPA in high-resolution mode.
Our breakout board gives you e…
SKU: 235911
Product Code: BMP085
Availability: In Stock
From:
£3.48
0.9-5V Input to 5V Output 600mA USB Charger DC-DC Converter Step Up Boost Module
Specifications:
Product Name
Step Up Boost Module
Input Voltage
0.9 to 5V
Output
5V, 600mA
Size
33 x 18 x 10mm/ 1.3" x…
SKU: 242395
Product Code: USBCHARGER
Availability: In Stock
£3.59
ESP8266 Serial WIFI Module Adapter Plate for use with ESP-07 ESP-08 ESP-12
Description
ESP8266 Serial Wireless WIFI Module Adapter Plate.
This is an Adapter Plate is used to solder YOUR ESP-07, ESP-08 or ESP-12 module.
No ESP modules are supplied. Please see ESP8266…
SKU: 242583
Product Code: ESP8266-Plate
Availability: In Stock
£3.59
Micro USB DIP Adapter Converter 5pin for 2.54mm PCB Breakout Board Power Supply
Features:
The USB to DIP 5pin 2.54mm PCB Board for DIY Power Supply and USB projects.
This module is used as a breakout board from a standard USB port to a conventional DIP2.54mm pin
…
SKU: 242368
Product Code: MICROUSB-DIP-5PIN
Availability: In Stock
£3.59
USB to DIP Adapter Converter 4pin for 2.54mm PCB Breakout Board DIY Power Supply
Features:
The USB to DIP 5pin 2.54mm PCB Board for DIY Power Supply and USB projects.
This module is used as a breakout board from a standard USB port to a conventional DIP2.54mm pin
…
SKU: 242363
Product Code: USB-DIP-4PIN
Availability: In Stock
£3.59
HC-SR505 Mini Infrared PIR Motion Sensor Precise Infrared Detector
Small passive infra-red detector
Automatic sensing: By entering into the sensing range the output will go high, when there is no activity the output will automatically go low after a delay …
SKU: 244591
Product Code: HC-SR505
Availability: In Stock
£3.59
3.5inch To 5.25inch Hard Drive Mounting Converter
Description
MOUNTING RAILS
SKU: 227338
Product Code: SHKIT
Availability: In Stock
£3.59
ATMEL ATMEGA88PA-PU MCU 8BIT 8KB FLASH DIP 28 Pin
Product Details
ADC Channels
6
ADC Resolution
10bit
ADCs
6 x 10 bit
Data Bus Width
8bit
…
SKU: 242391
Product Code: ATMEGA88PA-PU
Availability: In Stock
£3.59
2 X USB Ports - 2 X 5Pin Connector
Description
2 Port USB main board receptable [2 x USB external ports to 1 x 10pin Motherboard connector]
SKU: 227254
Product Code: COUSB0100
Availability: In Stock
£4.79
