In stock only 
ENC28J60 Ethernet Breakout Board for use with Microcontrollers
£5.99
Description
This is a ENC28J60-based ethernet development board for use with microprocessors such as PICs or AVRs.
- Fully pre-populated board - ready to use!
- 10Mbit ethernet controller to provide fast network access to your projects!
- Communicates via the SPI interface - fast interface available in hardware on most microprocessors.
- Large 8KB transmit/receive buffer
- Hardware assisted IP checksum calculation
The onboard connector pinout is as follows:
| CLK OUT | INT |
| WOL | SO |
| SI | SCK |
| CS | RESET |
| VCC | GND |
The network module is designed for use with 3.3V microcontrollers and must be powered with 3.3V. However, the CS, SCK, SI and RESET inputs are all 5V tolerant for easy interfacing. If you intend to use this network module with a 5V microcontroller then you may need the level converter option above for use between the network module's outputs and the microcontroller's inputs. It will need to be connected as follows:
For more information, please see the ENC28J60 datasheet.
