Welcome visitor, please login or create an account.

Outdoot / Indoor Long Range Wireless Access Point / Client Bridge 2.4Ghz EOC-2611 USED

Outdoot / Indoor Long Range Wireless Access Point / Client Bridge 2.4Ghz EOC-2611 USED
Manufacturer: EnGenius
Product Code: EOC-2611
Availability: In Stock
FastFind: 227744
£59.99

Description

Description

Description

This is a clearance item
This item has been used and shows signs of weather discolour. However the item has been fully tested and functioning. Comes with a 30 days warranty.

Contents:
                EOC-2611
                Power injector module
                24V DC Power Adaptor

Features

Wireless - 2.4GHz It works in 2.4GHz frequency spectrum
- High output power Transmit high output power programmable for different country selections
- High Data Rate High speed transmitting rate up to 108Mbps with Super G, support large payload such as MPEG video streaming
- Multifunction application Access Point/Client Bridge/Client Router/WDS Function
- Long range transmitting Transmit power control and distance control (ACK timeout)
- Narrow Bandwidth Provide 5MHz/10MHz/20MHz bandwidth selection
- Signal Strength Display RF signal strength status shown LEDs of 3 colors, making network build-up easier. LED indicators have
the best transmit and receive signal for traffic communication
- Multiple SSID 4 SSID supported. Each SSID can set itself wireless or WAN access setting.
QoS(WMM) Enhance performance and density
Networking - PPPoE Point-to-Point Protocol over Ethernet at Client Router mode. This function will keep trying when failed or disconnected
- PPTP Point-to-Point Tunneling Protocol (PPTP) is a method for implementing virtual private networks
- VPN Pass Through
Security - 802.11i WEP, WPA, WPA2 (Encryption support TKIP/AES)
- MAC address functions MAC address filter (AP mode)
- 802.1x IEEE802.1x Authenticator
- Station isolation L2 Isolation
Management - Firmware Upgrade Upgrading firmware via web browser, setting are reserved after upgrade
- Reset & Backup Reset to factory default. User can export all setting into a file via WEB
- Ping & Trace Route Built-in PING function & Trace Route function in Web GUI
- MIB MIB I, MIB II(RFC1213) and Private MIB
- SNMP V1, V2c
Hardware Specification
MCU/RF Atheros AR2316 Single Chip
Memory 32MB SDRAM
Flash 8MB
Physical Interface One 10/100 Fast Ethernet RJ-45
One Reset Button
One SMA Connector
One switch (external and internal antenna switching)
LED indicators Power/ Status
LAN (10/100Mbps)
WLAN (Wireless is up)
3 x Link Quality (Client Bridge mode)
- Green: Good Quality
- Yellow: Marginally Acceptable Quality
- Red: Bad Quality
Power Requirements Active Ethernet (Power over Ethernet) Proprietary PoE design
Power Adapter 24V / 0.6A DC
Regulation Certifications FCC Part 15C/15B, EN 300 328, EN 301 489-1/-17, EN60950
RF Specification
Frequency Band 802.11b/g
2.412~2.472GHz
Operating Channels 802.11b/g
11 for North America, 14 for Japan, 13 for Europe
Receive Sensitivity (Typical) 802.11g
-92 dBm @ 6Mbps
-74 dBm @ 54Mbp
802.11b
-97 dBm @ 1Mbps
-89 dBm @ 11Mbps
Internal Antenna 10dBi

Specification

Modems / Routers Cable Router
RJ45 Ports 1
Supports 3G? No
Wireless 802.11b/g, 54Mbps
Powered by Flexibasket