Generic
Light Dependent Resistor LDR
Description
These high quality and compact light dependent resistors are ideal for any situation where you need your project to act differently depending on the level of light.
These LDRs decrease i…
SKU: 236248
Product Code: LDR
£0.60
PP3 Battery Clip making it easy to power your project
This high-quality PP3 battery clip will fit any standard PP3 battery connector and has 100mm leads suitable for soldering!
SKU: 233003
Product Code: PP3CLIP
From:
£0.99
SMD Surface Mount 0805 Series Resistors
The 0805 series of surface mount resistors is a popular range ideal for use for both the professional and the hobbyist.
Surface mount resistors are designed for use on PCBs - these resistors ca…
SKU: 233942
Product Code: RESISTOR/SMD/0805
From:
£0.99
SMD Surface Mount 1206 Series Resistors
The 1206 series of surface mount resistors is a popular range ideal for use for both the professional and the hobbyist.
Surface mount resistors are designed for use on PCBs - these resistors can be…
SKU: 237975
Product Code: RESISTOR/SMD/1206
From:
£0.99
Lmr200/Hdf200 Cable For Making Pig Tails Low Loss 0.5Db Signal Loss At 2.4Ghz Bare Ends Per Meter
Excellent industrial strength shielding (HDF-200) for minimum cable loss
SKU: 227760
Product Code: RG58/1
£1.19
DIY Prototype Project PCB Universal Development Board 5×7 cm
Features:
1. For point to point DIY soldering
2. Material: Single Side Copper PCB
3. Hole Diameter: about 1mm
4. Hole pitch: standard 2.54mm
5. Dimension: 5x7 cm
SKU: 242398
Product Code: DIY-PCB
£1.19
CR2032 2032 CMOS Battery holder
CMOS 2032 battery holder, ideal for soldering to most motherboards in which the current battery holder has been damaged or your projects which need powering from a CMOS CR2032 battery
Easy to solde…
SKU: 242396
Product Code: CR2032-HOLDER
£1.19
Low Profile Network Bracket
Low Profile bracket for wired network connection.
SKU: 227505
Product Code: LP-NET
£1.19
SW520D Ball Angle Tilt Vibration Shaking Switch Sensor
Tilt Switch with internal ball that will switch to ON state of approx. 15 degrees tilt. Also great for sensing excessive vibration
Material: Housing and cover: PE heat shrinkable tubing/ Ball…
SKU: 240959
Product Code: SW520D
From:
£1.49
JoyStick Breakout Module
Description
100% brand new and high quality.
PS2 joystick standard interface module electronic building blocks and 2.54mm pin interface leads.
Has a two-way rocker 10K Variable resistor.
Spring …
SKU: 242374
Product Code: PS2-JOYSTICK
£2.39
BMP085 Barometric Pressure and Temperature Sensor - 3.3V and 5V
The BMP085 low-power, high-precision barometric pressure sensors can measure between 300 to 1100hPa with an accuracy of approximately 0.03hPA in high-resolution mode.
Our breakout board gives you e…
SKU: 235911
Product Code: BMP085
From:
£3.48
Sma Male Connector For RG58 Cable
The SMA connector consists of a 0.250x36 thread. The male is equipped with a .312 " hex nut. It is important that the nut be properly torqued with a 5/16 " wrench, 3-5 in·lbf (0.3 to 0.6 N·m) for bras…
SKU: 227770
Product Code: SMA-PLUG-RG58
£3.59
4 Channel IIC I2C Logic Level Converter Bi-Directional Module 3.3v - 5v
Description
Connects a 3.3V device to a 5V system
Steps down 5V signals to 3.3V AND steps up 3.3V to 5V simultaneously
This level converter also works with 2.8V and 1.8V devices.
Sets high and l…
SKU: 242371
Product Code: IIC-I2C-Logic
£3.59
PP3 Battery Box - with 15cm leads
Description
Our high quality plastic PP3 battery box is great for any project needing easily changeable 9V power.
The robust plastic construction protects the battery once it has been inserted, and …
SKU: 238212
Product Code: PP3 Battery Box
£3.59
CPU Heatsink Compound - Enough For 1 Application
Thermal grease is primarily used in the electronics and computer industries to assist a heatsink to draw heat away from a semiconductor component such as an integrated circuit or transistor .
Thermal…
SKU: 227864
Product Code: Heat-Sink-COMP
£3.59